---
title: Audio & Voiceover
description: Set track volumes, remove background noise from your microphone, record a voiceover after you record, and add sound effects.
url: https://www.screenkite.com/guide/audio-voiceover
---

# Audio & Voiceover

All audio work is in the **Audio** tab of the inspector. The tab has two parts: **Mix** and **Add**.

## Mix

| Section | What it does |
|---------|--------------|
| **Volume (this clip)** | Sets the volume of the selected clip. |
| **Tracks** | Lists each audio track, such as **Microphone**, **System Audio**, **Voiceover** and **Background Music**. Each track has a **Volume** control, **Mute** and **Solo**. |
| Ducking | Lowers other audio while you speak. See [Background Music](https://www.screenkite.com/guide/background-music). |
| **Listen to Mix** | Plays the audio mix so you can check it. |
| **Loudness** | Sets the loudness **Target** for audio enhancement. |

Open the menu of a track for more options, such as **Audio Channels** (**Stereo**, **Mono (Center)**, **Use Left Channel**, **Use Right Channel**) and **Show on timeline**.

## Remove Background Noise

**Audio enhancement** shows under the microphone track in **Tracks**. It runs on your Mac. It removes keyboard clicks, fans and room hum.

1. Click the **Audio** tab, then **Mix**.
2. Under the microphone track, turn on **Audio enhancement**.
3. If the v9 engine is available, choose **Noise Reduction** or **Studio**.
4. Set **Strength**. A strong setting can make the voice sound thin.

ScreenKite keeps the original audio, so you can turn enhancement off again.

[Remove background noise (YouTube)](https://www.youtube.com/watch?v=4UTWgL0i3pE)

### Default engine

Choose the default engine in **Settings** → **Audio** → **Audio enhancement**:

- **Always v9 (Noise Reduction)** (default)
- **Always v8 (Screen Studio Voice)**
- **Always v7 (Studio Voice)**

A choice that you make on a clip in the inspector takes priority over this setting.

> v9 needs Apple Silicon. See [System Requirements](https://www.screenkite.com/guide/system-requirements).

## Record a Voiceover

You can record your voice after the screen recording is done.

1. Move the playhead to where the voiceover starts.
2. Click the **Audio** tab, then **Add**.
3. In **Voiceover**, choose a **Microphone**.
4. Click **Record voiceover from playhead**.
5. Speak. Click **Stop recording** when you are done, or **Cancel** to discard it.

The voiceover goes on its own track. You can also right-click a timeline lane and choose **Record Voiceover**.

[Add a voiceover after recording (YouTube)](https://www.youtube.com/watch?v=Nz4rD68Pb2c)

## Replace the Audio

To use a different audio file for a clip, right-click the clip and choose **Replace Audio...**. Then choose the file.

## Sound Effects

1. Click the **Audio** tab, then **Add**.
2. Open **Sound effects** and click **Browse sound effects**. The Assets panel opens with sound effects.
3. Preview a sound, then add it to the timeline.

## Related Guides

- [Background Music](https://www.screenkite.com/guide/background-music)
- [Webcam & Microphone](https://www.screenkite.com/guide/webcam-microphone)
- [System Audio](https://www.screenkite.com/guide/system-audio)
- [Text-Based Editing](https://www.screenkite.com/guide/text-based-editing)
